EasyEcu 3+ with USB interface

The EasyEcu 3+ controller is designed to control motors with a maximum number of cylinders 8. As the software develops, support for various triggers and ignition systems will be added. In the initial phase triggers will be supported in the form of gears, e.g. 60-2, 36-1 and wasted spark ignition systems and on the ignition distributor. In addition, EasyEcu 3+ has a built-in Bosch LSU4.9 broadband lambda sensor controller and a 3 bar MAP sensor.

The hardware capabilities (inputs / outputs) of the EasyEcu 3+ controller are as follows:

outputs:
2 outputs of high-resistance injectors (in one or two banks)
4 ignition outputs (passive coils) Note 1
6 logic level 5V ignition outputs (active coils)
1 free spool valve (electromagnetic type)
1 idle valve (stepper motor) Note 2
1 fuel pump relay
1 additional output in an open collector system with a capacity of 3A
1 output of the 12V rev counter
Inputs:
1 shaft position input (VR or HALL)
1 shaft position input or reference on the shaft (VR or HALL)
1 shaft position input dedicated for ignition systems with a distributor (HALL)
1 vehicle speed sensor input
1 motor temperature sensor input
1 input of the intake air temperature sensor
1 throttle position sensor input
1 input of narrowband lambda probe
1 input for measuring the exhaust temperature
2 function inputs (eg start procedure switch)
2 analog inputs 0-5V
1 additional temperature measurement input
2 inputs of knock sensors
Note 1 and 2 It is possible to extend the ignition outputs on passive coils with an additional 4 channels. Additional ignition outputs are placed on the control outputs of the idle valve in the form of a stepper motor. In this option only the control of the electromagnetic slow-speed valve is available. In return, we obtain 8 ignition channels that support passive coils. Select the appropriate option when ordering (Hardware options).